Power Failure - Hoover SIX.AAA WHISPER 1600 AAA 160 Instructions For Use Manual

05651106 22/11/00 8:31 pm Page 33
It is unlikely that water will be visible in the drum! This
is due to the latest technology that achieves the same
standard of washing and rinsing but with far less water
consumption.
Note:
The use of environmentally-friendly, phosphate-free detergents (check detergent
information on pack) can have the following effects:
– waste water from rinsing may be cloudier because of the presence of a white
powder (zeolites) held in suspension, without the rinse performance being
adversely affected;
– presence of white powder on laundry after washing, which is not absorbed by
the fabric and does not alter the colour of the fabric.
– The presence of foam in the final rinsing water is not necessarily an indication
of poor rinsing.
– Carrying out more rinse cycles does not serve any purpose in such cases.
If there is a power failure the wash cycle will be interrupted, the wash programme
and functions will be suspended.
When the power is restored, the wash programme and functions will re-start from
the same point and complete the programme.
The load can be removed from the machine during a power failure as follows:
The water can be drained from the machine by:
1. Switch off the machine by the control knob and at the mains power supply.
Remove the plug from the mains power supply socket.
2. Carefully move the machine so the rear of the machine is accessible. Please
follow the safety precautions which we recommend under the 'safety notes'
section of this manual.
3. Unclip the drain hose from the rear panel of the machine and lower the hose
into a bowl on the floor.
Important: the water may be very hot!
Important: the water may be very hot!

Power failure

33