Lexus LS600L Dismantling Manual page 20

3. Carry the removed service plug grip in your pocket to prevent other staff from
accidentally reinstalling it while you are dismantling the vehicle.
4. Make other staff aware that a
high-voltage system is being
dismantled by using the following
sign: CAUTION: HIGH-VOLTAGE.
DO NOT TOUCH (see page 17).
5. If the service plug grip cannot be
removed due to damage to the rear
portion of the vehicle, remove the
IGCT No. 1 fuse (25A).
Caution:
This operation shuts off the HV
system. Be sure to wear insulated
gloves because high voltage is not
shut off inside the HV battery.
When it is possible to remove the
service plug grip, remove it and continue the procedure.
6. After disconnecting or exposing a high-voltage connector or terminal, insulate it
immediately using insulating tape. Before touching a bare high-voltage terminal,
wear insulated gloves.
7. Check the HV battery and nearby area for leakage. If you find any liquid, it may be
strong alkaline electrolyte. Wear
rubber gloves and goggles and
neutralize the liquid using a saturated
boric acid solution or vinegar. Then
wipe up the liquid using waste rags
etc.
8. If the electrolyte comes into contact
with your skin, wash the skin
immediately using a saturated boric
acid solution or a large amount of water. If the electrolyte adheres to any article
of clothing, take the clothing off immediately.
9. If the electrolyte comes into contact with your eye(s), call out loudly for help. Do
not rub your eye(s). Instead, wash the eye(s) with a dilute boric acid solution or a
large amount of water and seek medical care.
10. With the exception of HV battery, remove parts by following procedures which are
similar to conventional Lexus vehicles. For the removal of HV battery, refer to
the following pages.
Fuse box
IGCT No. 1
fuse
16