How To Clean - Hamilton Beach 840143800 Owner's Manual

840143800 ENv03.qxd

How to Clean

1. Unplug blender from electrical outlet.
2. Wipe blender base, control panel,
and cord with a damp cloth or
sponge. To remove stubborn spots,
use a mild, non-abrasive cleanser.
3. To clean jar, unscrew cutting assem-
bly from jar.
4. Carefully remove gasket from cutting
assembly.
5. Remove dispenser from cutting
assembly.
• Rotate dispenser assembly 90
• Pull to remove dispenser assembly
6. Carefully wash cutting assembly,
dispenser assembly parts, gasket,
jar, and lid in hot, soapy water. Rinse
and dry thoroughly. Do not soak.
Do not wash cutting assembly,
dispenser assembly parts, gasket,
jar, or lid in a dishwasher.
7. Reassemble cutting unit assembly
onto jar, and replace jar onto blender
base. Ensure dispenser or spout cap
is fully pushed on spout and rotated
clockwise to lock into position
(reverse steps in number 5 above).
8. Store blender with lid ajar to
prevent container odor.
8
1/6/06 9:05 AM Page 8
degrees
counter-
clockwise to
unlock from
cutting
assembly.
from cutting
assembly.
OPTIONAL CLEANING
1. To unsnap actuator from hinge on
2. Lift and rotate actuator around
3. Lift dispenser cap and actuator
NOTE: All parts except the cutting
assembly may be washed in the dish-
washer on the top rack only. Some
part distortion may occur if your house-
hold dishwasher temperature is higher
than normal or if the parts are placed
too close to the heating element.
WARNING
Electrical Shock Hazard
• Disconnect power before cleaning.
• Do not immerse cord, plug or base
in any liquid.
Failure to follow these instructions can
result in death or electrical shock.
dispenser,
push dis-
penser with
thumb while
pulling dis-
penser lever
with fingers.
This releases
dispenser from
hinge.
hinge.
Unscrew dis-
penser cap.
straight up to
remove the
interior plug
attached to
the cap from
the dispenser
body.