Check Operation - Kenmore 79046622504 Installation Instructions Manual

3. Check if therange islevel b yinstalling a novenrackin
the(.enter of theovenandplacing a level o ntherack
(Figure 1 3)
4. Take 2 readings withthelevel p laced diagonally in
onedirection a ndthentheother.Levelthe range, i f
necessary, byadjusting t heleveling l egs.
5. Iftherange isnotlevel, contact acarpenter tocorrect
sagging orsloping floor.
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for (.are and (.leaning
of your range.
Do not touch the elements or burners. They may be hot
enough to cause burns.
Remove all packaging from the oven before testing.
1.[nstaJ[ Burner Bases and Burner Caps
This range is equipped with sealed burners as
shown (see Figure 15).
1. Unpack burner bases and burner caps.
2. Place burner bases over each gas opening.
3. Make sure the burner is properly aligned and leveled.
Place burner caps over appropriate burner bases.
Burner Cap
J /
Figure 13
Decorative Rear Trim lnstaJJation
(if required)
1. Disconnect the power from the range.
2. Make sure tile range is leveled.
3. Pull range toward you.
4. Measure the distance between the floor and the
surface underneath the cooktop frame.
5. Mark that distance on the wall where the decorative
trim will be installed.
6. Draw a line.
7. Place the top of the decorative trim under that line.
8. Using the screws provided fix the decorative trim into
the wall.
9. Slide the range back into position as far as it will go
and reconnect tile power source.
Trim
underneath the
Figure 14
Figure 15 Electrode
NOTE: There are no burner adjustments necessary on this
range.
2.Turn on Electrical Power and Open Main Shutoff
Gas VaIve
3.Check the Igniters
Operation of electric: igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
1.Push in and turn a surface burner knob to the LITE
position. You will hear the igniter sparking.
2. The surface burner should light when gas is available
to the top burner. Each burner should light within four
(4) seconds in normal operation after air has been
purged from supply lines. Visually check that burner
has lit.
3.Once the burner lights, the control knob should be
rotated out of the LITE position.
There are separate ignition devices for each burner. Try
each knob separately until all burner valves have been
checked.
10