Gas Conversion - Kenmore 79046622504 Installation Instructions Manual

Once regulator i s in place, o penthe shutoffvalve in the
gassupply line.Waita few minutes f or gasto move
through thegasline.
Leaktesting of the applianceshallbe conducted
accordingto the manufacturer's instructions.
Check f orJeaks. A_ter connecting therange t othegas supply,
check t hesystem f orleaks w itha manometer. Ifa manometer
isnotavailable, turnonthegas supply a nduse aliquid leak
detector atall j oints andconnections tocheck f orleaks.
Donot usea flameto check for leaks
fromgasconnections. Checking f or leaks witha flame
mayresult i n afire or explosion.
Allopenings inthewallor floorwhere the range isto be
installed mustbesealed.
Tightenall connectionsif necessary to prevent g as
leakage in the(ooktopor supply line.
Disconnect t his rangeandits individualshutoff
valvefromthegassupply pipingsystem duringany
pressure t estingof thesystem attestpressures greater
than1/2psig(3.5kPa or 14"(35,56 era)water column).
tsoJate the rangefrom the gassupplypiping system
byclosing itsindividual manual shutoffvalve during
any
pressure testing of the gas supply piping system at test
pressures equal to or less than 1/2 psig (3.5 kPa or
14"(35,56 cm) water column).
LPiPropane Gas Conversion
This applian(e (an be used with Natural gas or LP/Propane
gas. It is shipped from the factory for use with natural gas.
If you wish to convert your range for use with LP/Propane
gas, use the supplied fixed orifices located in a bag
containing tile literature marked "FOR LP/PROPANEGAS
CONVERSION." Follow the instructions packaged with
the orifices.
The conversion must be performed by a qualified service
technician in accordance with the manufacturer's
instructions and all local codes and requirements. Failure
to follow these instructions could result in serious injury
or property damage. The qualified agency performing
this work assumes responsibility for the conversion.
Failure to make the appropriate
conversion can result in personal injury and property
damage.
Moving the Appliance for
Servicing and Cleaning
Turn off the range line fuse or circuit breakers at the main
power source, and turn off the manual gas shut-off valve.
Make sure tile range is cold. Remove tile service drawer
(warmer drawer on some models) and open the oven door.
Lift the range at the front and slide it out of tile cut-out
opening without creating undue strain on tile flexible gas
conduit. Make sure not to pinch the flexible gas conduit at
the back of the range when replacing the unit into tile cut-
out opening. Replace the drawer, close the door and switch
on the electrical power and gas to the range.