Table of Contents
Advertisement
Available languages
Available languages
Leveling
Decorative
Rear Trim Installation
(if required)
1.
Disconnect the power from the range.
2.
Make sure the range is leveled.
3.
Pull range toward you.
4.
Measure the distance between the floor and the
surface underneath the cooktop frame.
5.
Mark that distance on the wall where the decorative
trim will be installed.
6.
Draw a line.
7.
Place the top of the decorative trim under that line.
8.
Using the screws provided fix the decorative trim into
the wall.
9.
Slide the range back into position as far as it will go
and reconnect the power source.
Font
Leveling
Leg
LOWER
RAISE
Figure 7
Models
Equipped
with
Levelin_
Level the range and set cooktop
height
before
installation
in the cut-out
opening.
1.
Install an oven rack in the center of the oven.
2.
Place a level on the rack (see Figure 8). Take 2
readings with the level placed diagonally in one
direction and then the other. Level the range, if
necessary, by adjusting the 4 leg levelers with a
wrench (see Figure 17).
3.
Taking care to not damage the countertop,
slide
range into cutout opening and double check for
levelness.
Figure 8
oScrew (3)
:loor and
surface
underneath
"\the cooktop
fra_
Trim
Figure 9
Check Operation
to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Remove all packaging from the oven before testing.
Re-
|
Install
Burner
Bases
and
Burner
Caps
This
range
is
equipped
with
sealed
burners
as shown
(see
Figure
10).
a. Unpack burner bases and burner caps.
b. Place burner bases over each gas opening.
c. Make sure the burner is properly aligned and leveled.
Place burner caps over appropriate burner bases.
NOTE: There are no burner adjustments necessary on
this range.
9
Advertisement
Table of Contents
