Kenmore 721.86012 Installation Instructions Manual page 16

STEP 5: INSTALL THE MOUNTING
PLATE TO THE WALL
TO PREPARE THE REAR WALL
CUTOUT OPENING AND EXHAUST
ADAPTOR/MOUNTING PLATE FOR
WALL VENTING AND ROOF
VENTING:
* Make the box cutout for the rear wail duct.
- 1 piece mounting plate:
Using a pencil, put dots through slots F and
G, and through holes H and I. Remove the
mounting plate and draw lines extending
through the points. This wiil give the location
and size of the box cutout for the rear wail
duct. (Figure 28)
- 3 pieces mounting plate:
Use the wall template to determine the
location and size of the box cutout for the
rear wail duct.
* Attach the exhaust adaptor to the rear
mounting plate by sliding it into the guides at
the top center of the plate on the wail side.
Push in securely until it is past the top locking
tabs and in the lower locking tabs. Take care to
assure the damper hinge is installed so that it is
at the top and that the damper swings freely.
• Carefully guide the exhaust adaptor, now
attached to the mounting plate, into the house
duct, before using the screws to attach the
plate to the wall.
This wiii assure proper alignment for installation.
See Figure 29.
* Return to step 5, item 3 (page 15) to continue.
After completing the installation of the mounting
plate, again check the rear damper for free
movement to assure it wiJJ operate properly.
Figure 28
Exhaust Adapto_._
Slide exhaust
adaptor into
guides on
rear panel.
a
Figure 29
Damper
(hinge side up)
-Mounting Plate
(1 piece
mounting plate)
-Back Plate
(3 pieces
mounting plate)
Guides
16