Disposal; Manufacturer's Warranty - Tools - Hilti UD16 Operating Instructions Manual

Fault
The power tool doesn't start.
The power tool doesn't achieve
full power.
The drill bit makes no pro-
gress.
The drill bit doesn't rotate.

10. Disposal

Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, Hilti has already made
arrangements for taking back your old power tools or appliances for recycling. Please ask your Hilti customer
service department or Hilti representative for further information.
Return waste material for recycling.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of European Directive 2002/96/EC on waste electrical and electronic equipment
and its implementation in accordance with national law, electric tools that have reached the end
of their life must be collected separately and returned to an environmentally compatible recycling
facility.
11. Manufacturer's warranty ‐ tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid
so long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical
system is maintained. This means that only original
Possible cause
The supply cord or plug is defective. Have it checked by a trained
The control switch is defective.
The extension cord is too long or its
gauge is inadequate.
The control switch is not pressed
fully.
The forward/reverse switch is set to
reverse rotation.
The drill bit is blunt or damaged.
The chuck is not tightened securely. Retighten the chuck.
Hilti consumables, components and spare parts may
be used in the tool.
This warranty provides the free‐of‐charge repair or
replacement of defective parts only over the entire
lifespan of the tool. Parts requiring repair or replace-
Remedy
electrical specialist and replaced if
necessary.
Have it checked by a trained
electrical specialist and replaced if
necessary.
Use an extension cord of an
approved length and / or of
adequate gauge.
Press the control switch as far as it
will go.
Set the forward/reverse switch to
forward rotation.
Hone the drill bit or replace it.
en
29