Operation; Maintenance - Dimplex TFA36E Service Manual

OPERATION

Figure 1
Charging Cord
This electric fireplace is operated by a momentary switch
located on the bottom of the fireplace, under the right hand
corner (Figure 1-A).
Press the momentary switch to toggle the fireplace's flame
effect on or off.
The battery charge LEDs (Figure 1-B) will indicate the
charge level of the battery. The LEDs read green, yellow
and red from right to left. Once the red battery charge LED
is lit, the electric fireplace should be plugged in to recharge.
The fireplace can operate while charging.
!
NOTE: The fireplace will shut off automatically if it is
unplugged during operation. The momentary On/Off Switch
will need to be activated to turn the fireplace on again.
B

MAINTENANCE

 
WARNINg: Disconnect power before attempting
any maintenance or cleaning to reduce the risk of fire,
electric shock or damage to persons.
!
NOTE: Even if the fireplace is not used regularly, the
battery should be fully recharged at minimum every three
(3) months to prolong battery life.
A
Partially Reflective Glass Cleaning
The partially reflective glass is cleaned in the factory during
the assembly operation. During shipment, installation,
handling, etc., the partially reflective glass may collect dust
particles; these can be removed by dusting lightly with a
clean dry cloth.
To remove fingerprints or other marks, the partially
reflective glass can be cleaned with a damp cloth. The
partially reflective glass should be completely dried with a
lint free cloth to prevent water spots. To prevent scratching,
do not use abrasive cleaners.
Fireplace Surface Cleaning
Use only a damp cloth to clean painted surfaces of the
fireplace. Do not use abrasive cleaners.
Servicing
Except for battery replacement and cleaning described
above, an authorized service representative should perform
any other servicing.
3