Table of Contents
Advertisement
BATTERY REPLACEMENT
Tools Required: Phillips Screw Driver;
Flat Head Screw Driver
Needle Nosed Pliers
WARNINg: Unplug or disconnect power before attempt-
ing any maintenance to reduce the risk of electric shock or
damage to persons.
WARNINg: To prevent damage to the electric fireplace
and to prevent bodily harm, only use Dimplex replacement
rechargeable batteries.
WARNINg: Improper handling of battery may result in
possible explosion hazard, electric shock and severe bodily
injury.
•
Do not dispose of battery in a fire, the battery may
explode
•
Do not open or mutilate battery. The battery contains
chemicals that are toxic to the eyes and skin
•
To decrease risk of electric shock, remove wrist
watches and jewelry such as rings and bracelets when
replacing battery.
•
To decrease risk of electric shock, only use tools with
insulated handles.
•
To prevent damage to the electric fireplace and to
prevent bodily harm, only replace battery with Dimplex
replacement rechargeable batteries.
•
To prevent damage to the electric fireplace and to
prevent bodily harm, only use Dimplex approved DC
power supply to power and recharge battery.
•
To dispose of spent battery, return it to place of
fireplace purchase, deliver it to a local recycling facility
or ship it to Dimplex North America Limited in the
replacement battery packaging material.
1.
Ensure the fireplace is turned OFF.
2.
Unplug the Power Supply cord from the unit (if at-
tached).
3.
Carefully remove the River Rocks (media) from the
Media Tray on the front of the fireplace
4.
Lift and remove the electric fireplace from the wall-
mounting bracket (Figure 2) and carefully place it
upright on a flat surface.
Figure 2
Front of Fireplace
6
Wall
Segment
Figure 3
CAUTION: A protective barrier (i.e. blanket) between
the fireplace and work surface will help prevent scratches
on the work surface or the fireplace.
5.
On the back of the fireplace, remove the eight (8)
screws securing the battery cover to the unit, located in
the bottom, right corner of the back panel (Figure 3).
6.
Lift and remove the battery access cover.
7.
Tilt the unit backwards, to allow the battery to slide out
of the opening.
!
NOTE: The battery is heavy so ensure that it will slide
out onto the flat surface.
CAUTION: Take care not to damage the 2 wire con-
nections on the left side of the battery. (Figure 3)
8.
Once battery is out of the opening, remove the two (2)
wire lead connectors from the battery terminals taking
note of their original configuration.
!
NOTE: These wire connectors can be carefully re-
moved one at a time by using needle nosed pliers.
9.
Reconnect the wire leads with black leading to black
and red leading to red to ensure correct polarity and
that they are not pinched when replacing the access
cover.
10.
Insert the replacement battery into the opening, careful-
ly orienting the wire leads so that they are not pinched.
11.
Replace the access cover and screws.
Battery must be recycled or disposed of properly.
Check with your Local Authority or Retailer for
recycling advice in your area.
FLICkER MOTOR REPLACEMENT
Tools Required: Phillips Screw Driver;
Flat Head Screw Driver
Needle Nosed Pliers
WARNINg: Unplug or disconnect power before attempt-
ing any maintenance to reduce the risk of electric shock or
damage to persons.
WARNINg: To prevent damage to the electric fireplace
Battery
Terminals
Battery
Battery Cover
www.dimplex.com
- Quick Links:
- Operation
- Exploded Parts Diagram
Hide quick links:
Advertisement
Table of Contents
