Installation Requirements; Tools And Parts - Whirlpool UXL6048YSS0 Installation Instructions And Use & Care Manual

INSTALLATION REQUIREMENTS
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools needed
• Level
• Drill
• 1W' (3 cm) drill bit
• V8" (3 mm) drill bit
• Pencil
• Wire stripper or utility knife
• Tape measure or ruler
• Pliers
• Caulking gun and weatherproof caulking compound
• Vent clamps
• Jigsaw or keyhole saw
• Flat-blade screwdriver
• Metal snips
• Phillips screwdriver
Parts needed
• Home power supply cable
• 1 - 1/2"(1.3 cm) UL listed or CSA approved strain relief
• 3 UL listed wire connectors
• 1 wall or roof cap
• Metal vent system
• Blower motor system - internal or external (see "Blower
Motor System" in the "Accessories" section).
Parts supplied
Remove parts from packages. Check that all parts are included.
• 3 metal grease filters
• Hood liner with halogen lamps installed.
• 1 - 10" (25.4 cm) square to 10" (25.4 cm) round duct
transition with damper.
• 4- 5 x 45 mm mounting screws
• 4- 4.2 x 8 mm screws
• T-20 TORX®t adapter
IMPORTANT." Observe all governing codes and ordinances.
Have a qualified technician install the hood liner. It is the
installer's responsibility to comply with installation clearances
specified on the model/serial rating plate. The model/serial rating
plate is located behind the left filter on the rear wall of the hood
liner.
The hood liner location should be away from strong draft areas,
such as windows, doors and strong heating vents.
Cabinet opening dimensions that are shown must be used. Given
dimensions provide minimum clearance.
The hood liner must be surrounded by a custom built enclosure
with hood support capable of supporting 75 Ib (34 kg).
Grounded electrical outlet is required. See "Electrical
Requirements" section.
All openings in ceiling and wall where canopy hood will be
installed must be sealed.
For Mobile Home Installations
The installation of this range hood must conform to the
Manufactured Home Construction Safety Standards, Title 24
CFR, Part 328 (formerly the Federal Standard for Mobile Home
Construction and Safety, Title 24, HUD, Part 280) or when such
standard is not applicable, the standard for Manufactured Home
Installation 1982 (Manufactured Home Sites, Communities and
Setups) ANSI A225.1/NFPA 501A, or latest edition, or with local
codes.
Cabinet Dimensions
;_-- 36" (91.4 cm) for 36" models __
48" (121.9 cm) for 48" models
L
.... ( ....
.... , .- / 22" (55.9 cm)
/_ .... -_ Hood liner depth
Hood support must be | ....
capable of supporting |
75 Ib (34 kg) J
"X" bottom
_ _ of canopy to
..... cooking surface
IM PO RTANT:
Minimum distance "X": 24" (61 cm) from electric cooking
surfaces.
Minimum distance "X": 30" (76.2 cm) from gas cooking
surfaces.
Suggested maximum distance "X": 36" (91.4 cm).
I"®TORX is a registered trademark of Saturn Fasteners, Inc.