Install The Water Inlet Hose - Haier XQB60-68 User Manual

Install the water inlet hose

Confirm the water faucet
Water faucet, suitable
It is required that the front end shall be longer than 10cm.
The outlet end surface of the faucet shall be flat and smooth. If not please file it to
avoid leakage.
Connection between the water inlet hose jointer and the water faucet
1.Press the lower end of the lock lever and push down the slider. Take off the
water inlet hose jointer from the water inlet hose component. See to Figure 1.
2.Loosen the screw till the water faucet can be accessed. Put the jointer of the
water inlet hose on the faucet. See to Figure 2. (If the faucet is too large and
the jointer can not be set on the water faucet, please loosen the four screws
and take out the bushing in the jointer. The front end of the faucet must be
smooth, otherwise it may leak water. See to Figure 3.)
Lock lever
Water inlet hose
Figure 1
3.Fasten the four screws evenly. See to Figure 4.
4.Take off the nameplate. Twist the fastening nut as per the indication of the
figure to seal up the outlet end surface of the faucet. See to Figure 5.
Remarks:
Before installation, the threading is 4mm above the upper surface of the
nut. After installation, the threading is 2mm above the upper surface of the nut.
See to Figure 6.
Figure 4
Water inlet hose jointer
Slider
Screwdriver
Figure 2
Water faucet, not suitable
Screw
Nameplate
Figure 3
Nut
Figure 5)
Bushing
About 4mm
before twisting;
about below 2mm
after twisting
Figure 6