Trouble-Shooting Answers To Question - Haier XQB60-68 User Manual

Trouble-shooting Answers to question

(If there's breakdown, please pull off the power plug before checking) The following
phenomena are not breakdowns sometimes. Please confirm again before sending it
to repair. If there are real breakdowns, please come to the special maintenance
department or after-sale service department of our company. Do not repair it by yourself.
Phenomenan
In spinning, the machine stops
running. (The "wash" "rinse"
"spin" indicator flash quickly)
The draining does not work,
or the speed of draining is
too slow ( the indicators of
"rinse" "spin" flash)
The safety switch acts. The
spinning can not work (the
indicators of "wash" "rinse"
flash quickly)
The program pauses after
about 15 minutes of water
inlet (the indicators of "wash"
"spin" flash quickly)
The machine does
not act.
There's abnormal sound
inside the machine.
The water faucet leaks.
Common phenomena
Phenomena
The spinning is intermittent when it starts.
Push the "Process selector" button to
select "Spin", but it doesn't work.
There may be some water flowing out of
the drain hose in the first use of the machine.
In the final spinning, it stops and displays
"Rinse", and starts water inlet.
The reason
The top lid is not closed.
Is the drain hose blocked
by foreign material?
Are the laundries put
slantingly?
Is the machine slanting?
The water faucet is not open.
The water inlet valve is
blocked
The water pressure is too low
and the current is too small.
Is there power failure?
No wash
Is the power plug loose?
If water level reach the appoint level?
Is the power plug loose?
No spin
Is the top lid is not closed.?
Are the laundries put
slantingly?
Is the machine slanting?
Are the laundries slanting
in spinning?
Is the jointer screw of the
water inlet hose is loose
or twisted awry?
Close the top lid.
Clean the foreign material.
Open and close the top lid once.
Re-order the laundries.
Close the top lid.
Level the machine in right position.
Open and close the top lid once.
Open the water faucet. Push
the "Start/Pause" button.
Clean the water inlet valve.
Push the "Start/Pause" button.
Wait for the normal water
pressure before use.
Use it when the power is on.
Insert the power plug tightly.
Affusion to appoint level.
Insert the power plug tightly.
Close the top lid
Re-order the laundries.
Close the top lid.
Level the machine properly.
Re-order the laundries.
Fasten the jointer screw
properly.
Explanation
Balance the laundries to avoid slanting.
The program is setting the drain time. Some
time is needed before it starts spinning.
It is the water remained in the factory
inspection of performance.
It is because that the laundries are slanting
to one side, and the safety switch acts. After
water inlet and stirring, the slanting will be
removed and the spinning will work.
How to settle