Installation And Adjustment - Haier WM6002A User Manual

Installation and adjustment

Please install and adjust the machine according to the requirement of the mannual.
It is very important to your security and correct operating the machine.
Install the inner cover and lint filter
1.Open the top lid of the washing machine.
2.Put the inner cover component on the outer tub cover, aiming
the inner cover shaft to the installation hole of the corresponding
outer tub cover shaft groove.
3.Firstly insert the inner cover shaft of one side into the correspon
-ding outer tub cover shaft groove, then push the another inner
cover shaft into the corresponding outer tub cover shaft groove.
Please install to designated position to guarantee there are no
dropping or abnormal sound in opening and closing of the inner
cover, and the operation shall be smooth. Do not dismount the
inner cover component after washing.
4.Install the lint filter in the balance ring.(See to the right figure)
Install the bottom plate
After opening the package, please lean the washing
machine gently down on soft items (like towel cloth,
blanket, etc.). Installthe bottom plate to the bottom of
the machine with eight screws by a cross screwdriver,
then lift the machine up gently. (See to the figure)
Adjust the Installation position
The washing machine away from wall should be overrun 20mm.The largest allowable slope of the shank base of
the machine is 2 .The slanting or rough ground will result in unstable running or stoppage of the machine.
Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Before Using
Before Using
Install the lint filter
Loosen Fasten
High
Low
Outer tube cover
Inner cover shaft
Inner cover
Back
Front
bottom plate
Soft object
Screw
the adjustable nut
the adjustable foot