Table of Contents
Advertisement
Locks and Security
one minute of keypad inactivity.
the
control is pressed on the remote entry transmitter.
the ignition is turned from the 1 (OFF/LOCK) position to the 3 (ON)
position, or from the 3 (ON) position to the 1 (OFF/LOCK) position.
Programming a personal entry code
To create your own personal entry code:
1. Enter the factory set code (keypad will illuminate when pressed).
2. Within five seconds press the 1
3. Enter your personal 5-digit code. Each number must be entered
within five seconds of each other.
4. After the code is entered, the locks will cycle, confirming that the new
code has been set.
Tips:
Do not set a code that uses five of the same number.
Do not use five numbers in sequential order.
The factory set code will work even if you have set your own personal
code.
If you set a second personal code it will erase your first personal code.
Erasing personal code
1. Enter the factory set 5–digit code.
2. Press and release 1
3. Press and hold the 1
five seconds of completing Step 1.
Your personal code is now erased and only the factory set 5–digit code
will work.
Unlocking and locking the doors using keyless entry keypad
To unlock the driver's door, enter the factory set 5-digit code or your
personal code. Each number must be pressed within five seconds of each
other. Note: The driver's door will unlock and the interior lamps will
illuminate after the factory set 5-digit code or your personal code are
correctly entered.
To unlock all doors, press the 3
To lock all doors, press the 7
do not need to enter the keypad code first. Note: The interior lamps
will turn off.
154
2008 F-150
Owners Guide (post-2002-fmt)
USA
2 on the keypad.
2 then,
2 for two seconds. This must be done within
4 control within five seconds.
8 and the 9
0 at the same time. You
Advertisement
Table of Contents
