Ford Mondeo Owner's Manual page 116

Programming the function One-Time
1. Highlight One-Time and press the right
arrow button.
2. Press the OK button and the hours
flash. Use the up and down arrow
buttons to adjust the individual settings
and the left and right arrow buttons to
move to the next or previous setting.
3. When you have finished, press the OK
button again to confirm the selection.
Active now
Highlight Active now and press the OK
button. A cross appears in the box next to
the function to show that the heater is
activated.
To deactivate the heater, highlight Active
now and press the OK button again.
Remote starting
The parking heater may be started and
switched off from a distance of up to 500
metres (1640 feet) using the supplied
remote control transmitter. This range will
vary depending upon local conditions and
terrain, as well as battery condition. The
remote control transmitter will indicate
whether or not the signal has been
received. The parking heater will operate
for a maximum of 30 minutes.
Note: The heater will operate, depending
on the ambient temperature, for between
10 and 30 minutes. The interior will cool
down after the heating period has elapsed,
therefore a remote start more than 30
minutes before driving is not recommended.
Note: The remote control may not always
receive confirmation of a successful remote
command at extended operating ranges.
Climate Control
Starting
Hold the transmitter with the antenna
upwards and press the ON button for at
least two seconds. The LED on the
transmitter lights up green to confirm the
signal has been received.
Switching off
Hold the transmitter with the antenna
upwards and press the OFF button for at
least two seconds. The LED on the
transmitter lights up red to confirm the
signal has been received.
Remote start in combination with
direct start or timer
E114360
Remote start is integrated with normal
heater control. Parking heaters started with
direct start or timer functions can be
switched off with the remote control
transmitter and vice versa.
Feedback during starting and
switching off
The LED on the transmitter illuminates
green for about two seconds. This
indicates the signal has been received by
the vehicle and the heater has started.
The LED on the transmitter illuminates red
for about two seconds. This indicates the
signal has been received by the vehicle and
the heater has switched off.
114