Table of Contents
Advertisement
4.If extra drain hose is needed , please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
If the extra hose is too long, cut it either
at point A or B.
How to change the direction of the drain hoses
Figure 1 indicates the leave factory installation
position of the drain hose.
Extend the drain hose from the side of wash tub
Put soft items on the ground. Lean the machine
down gently with the front surface facing the
ground. Take off the drain hose from the cabinet.
Take the hose out of the fixing groove.
(See to Figure 2).
Embed the drain hose into the groove along the side
of the wash tub in the order of (1)~(2), heading for the
side of the wash tub. (See to Figure 3).
Embed the drain hose into the groove with
hands. Take care not to damage the drain
hose in fastening the fixing clamp.
Extend the drain hose from the rear side
Take out the drain hose from the fixing groove. Extend it from
the rear side as per the direction of the arrow. (When the drain
hose is extended from the rear side, it can be hung on the
point for drain hose at the two sides of the cabinet.)
(See to Figure 4).
Install the water inlet hose; Select the water level
Insert the water inlet hose into the water-filling
entrance on the control panel directly. (pull it
out to dismantle it)
Select water level according to the
quantity of the laundries.
Adjust the water level adjusting lever to
desired water level line.
Attention:
In water filling, do not exceed
the"High" water level. Otherwise
the water may overflow out of the
washing machine.
A
Soft item
Soft item
Embed into the
groove in turn
Water inlet hose
Water level
indicator
MAX
MAX
MED
MED
MIN
MIN
> 30mm
<1.5m
B
Back
Front
Figure 1
Figure 2
Extend to the
wash tub side
Figure 3
Figure 4
Water-filling
entrance
5
Advertisement
Table of Contents
