NETGEAR JNR3000 User Manual page 12

Table 1. Front panel LED descriptions
LED Description
Power/Test • Solid green. The startup is completed, and the router is ready.
• Blinking green. The firmware is corrupted (see http://www.netgear.com/support).
• Blinking amber. The firmware is upgrading, or the Reset button was pressed.
• Off. Power is not supplied to the router.
Internet
• Solid green. An IP address has been received; ready to transmit data.
• Solid amber. An Ethernet cable connection to the modem has been detected.
• Off. No Ethernet cable is connected to the modem.
LAN ports • Solid green. The local port is connected to a 1000 Mbps device.
1–4
• Blinking green. Data is being transmitted at 1000 Mbps.
• Solid amber. The local port is connected to a 10/100 Mbps device.
• Blinking amber. Data is being transmitted at 10/100 Mbps.
• Off. No link is detected on this port.
Wireless
• Solid blue. The wireless interface is enabled.
• Blinking blue. Data is being communicated over the wireless network.
• Off. The wireless interface is turned off.
WPS
• Solid green. A WPS-capable device has been accepted by the router and is ready to be used.
• Blinking green. The WPS-capable device will be associated with the router within 2 minutes.
• Off. No WPS connection exists.
The WLAN and WPS buttons toggle the WLAN and WPS functions on and off.
• Wireless On/Off button. Pressing and holding the wireless LAN button for 2
seconds turns the 2.4 GHz wireless radio on and off. If the Wireless LED is lit, the
wireless radio is on. If the LED is off, then the wireless radio is turned off and you cannot
connect wirelessly to the router.
• WPS button. You can use this button to use WPS to add a wireless device or
computer to your wireless network. The LED below the WPS button blinks green when
the router is trying to add the wireless device or computer. The LED stays solid green
when wireless security is enabled in the router.
N300 Wireless Gigabit Router JNR3000
Hardware Setup
12