Table of Contents
Advertisement
Installation
As shown in figure1 remove all the packing materials
(including the foam base).
Upon opening of the package, water drops may be seen on
the plastic bag and the porthole. This in normal phenomenon
resultingfrom water test in the factory.
Check attachments and materials.
Name
Qty
Model
HA1000TE
HA800TE
HA600TE
Remove the packing screws as shown in figure 2.
The packing bolts protect the appliance from shock during trans-
portation The steps below should be followed before using the
appliance,
1. Remove the rear panel of the washing machine;
2. Remove the three packing bolts from the rear panel of the wash-
ing machine,the rubber hose and then the shock absorption chan-
nel steel;
3. Reinstall the back plate;
4. Fill the holes left by the packing bolts with plastic plugs.
(Attention: the packing bolts and rubber hose should be kept in a
safe place for later use)
Adjusting the position of the washing machine .There are ad-
justable feet under the bottom of the washing machine. Before use,
the washing machine should be adjusted, as shown in figure 3, so
that it is level.
4
Operational
Quality
manual
certificate
1
1
Water
Drainage
hose
holder
1
1
Fig 1
Plastic
plugs
3
Fig 2
Fig 3
Advertisement
Table of Contents
