Edit Or Delete A Port Forwarding Entry; Set Up Port Triggering - NETGEAR WNR612v3 User Manual

In the Service Name field, enter a descriptive name.
4.
In the Protocol list, select the protocol. If you are unsure, select TCP/UDP.
5.
In the Starting Port field, enter the beginning port number.
6.
If the application uses a single port, enter the same port number in the Ending Port
•
field.
If the application uses a range of ports, enter the ending port number of the range in
•
the Ending Port field.
In the Server IP Address field, enter the IP address of your local computer that will provide
7.
this service.
Click Apply. The service appears in the list in the Port Forwarding/Port Triggering screen.
8.

Edit or Delete a Port Forwarding Entry


To edit or delete a port forwarding entry:
In the table, select the radio button next to the service name.
1.
Click Edit Service or Delete Service.
2.
Application Example: Making a Local Web Server Public
If you host a web server on your local network, you can use port forwarding to allow web
requests from anyone on the Internet to reach your web server.

To make a local web server public:
Assign your web server either a fixed IP address or a dynamic IP address using DHCP
1.
address reservation. In this example, your router always gives your web server an IP
address of 192.168.1.33.
In the Port Forwarding screen, configure the router to forward the HTTP service to the local
2.
address of your web server at 192.168.1.33. HTTP (port 80) is the standard protocol for web
servers.
(Optional) Register a host name with a Dynamic DNS service, and configure your router to
3.
use the name as described in
the Internet, a remote user has to know the IP address that your ISP assigned. However, if
you use a Dynamic DNS service, the remote user can reach your server by a user-friendly
Internet name, such as mynetgear.dyndns.org.

Set Up Port Triggering

Port triggering is a dynamic extension of port forwarding that is useful in these cases:
More than one local computer needs port forwarding for the same application (but not
•
simultaneously).
An application needs to open incoming ports that are different from the outgoing port.
•
When port triggering is enabled, the router monitors outbound traffic looking for a specified
outbound "trigger" port. When the router detects outbound traffic on that port, it remembers
N150 2-Port Wireless Router WNR612v3
on page 73. To access your web server from
Dynamic DNS
Advanced Settings
71