Netgear Genie Setup - NETGEAR WNR612v3 User Manual

NETGEAR genie Setup

NETGEAR genie runs on any device with a web browser. Installation and basic setup takes
about 15 minutes to complete.

To use NETGEAR genie to set up your router:
Turn the router on by pressing the On/Off button.
1.
Make sure that your computer or wireless device is connected to the router with an Ethernet
2.
cable (wired) or wirelessly with the preset security settings listed on the bottom label.
Launch your Internet browser.
3.
The first time you set up the Internet connection for your router, the browser goes to
•
http://www.routerlogin.net and the NETGEAR genie screen displays.
If you already used the NETGEAR genie, type http://www.routerlogin.net in the
•
address field for your browser to display the NETGEAR genie screen. See
NETGEAR genie After Installation
Follow the onscreen instructions to complete NETGEAR genie setup. NETGEAR genie
4.
guides you through connecting the router to the Internet.
If the browser cannot display the web page:
Make sure that the computer is connected to one of the four LAN Ethernet ports or
•
wirelessly to the router.
Make sure that the router has full power, and that its wireless LED is lit.
•
Close and reopen the browser to make sure that the browser does not cache the previous
•
page.
Browse to
• http://www.routerlogin.net.
If the computer is set to a static or fixed IP address (this is uncommon), change it to
•
obtain an IP address automatically from the router.
If the router does not connect to the Internet:
Review your settings to be sure that you have selected the correct options and typed
1.
everything correctly.
Contact your ISP to verify that you have the correct configuration information.
2.
Read
3. Chapter 8,
contact NETGEAR technical support.
N150 2-Port Wireless Router WNR612v3
on page 14.
Troubleshooting. If problems persist, register your NETGEAR product and
Getting Started with NETGEAR genie
13
Use