NETGEAR DGN3500 User Manual page 27

N300 Wireless Gigabit ADSL2+ Modem Router DGN3500
To use the wireless modem router WPS button to add a WPS client:
Log in to the wireless modem router at its default LAN address of http://192.168.0.1 with
1
its default user name of admin and default password of password, or using whatever
LAN address and password you have set up.
On the wireless modem router main menu, select Add a WPS Client, and then click Next.
2
The following screen displays:
Figure 10.
By default, the Push Button (recommended) radio button is selected.
Either press the WPS button, or click the on screen button.
3
The wireless modem router tries to communicate with the client for 2 minutes.
Go to the client wireless computer, and run a WPS configuration utility. Follow the utility's
4
instructions to push or click a WPS button.
Go back to the wireless modem router screen to check for a message.
5
While the wireless modem router attempts to connect to a WPS-capable device, the
•
Push 'N' Connect LED on the front blinks green. When the wireless modem router has
established a WPS connection, the LED is solid green.
If a connection is established, the wireless modem router WPS screen displays a
•
message confirming that the wireless client was successfully added to the wireless
network. (The wireless modem router has generated an SSID, implemented
WPA/WPA2 wireless security [including a PSK security password] on the wireless
modem router, and has sent this configuration to the wireless client.)
Note the new SSID and WPA/WPA2 password for the wireless network.
6
To access the Internet from any computer connected to your wireless modem router,
launch a browser such as Microsoft Internet Explorer. You should see the wireless
modem router's Internet LED blink, indicating communication to the ISP.
If no WPS-capable client devices are located during the 2-minute
Note:
timeframe, security will not be implemented on the modem router.
Configuring Your Wireless Network and Security Settings
WPS button
28