Adjusting The Pc Image Automatically; Adjusting The Pc Image Manually - Sharp Aquos LC-32DH57E Operation Manual

Connecting a PC
Adjusting the PC image
automatically
This function enables the screen to be automatically
adjusted to its best possible condition when the analogue
terminals of the TV and PC are connected with a
commercially available DVI/RGB conversion cable, etc.
Setup
Auto Sync.
NOTE
• "Auto Sync." may fail if the PC image has low resolution, has
unclear (black) edges, or is moved while executing "Auto
Sync.".
• Be sure to connect the PC to the TV and switch it on before
starting "Auto Sync.".
• "Auto Sync." can be executed only when inputting analogue
signals through the EXT 4 terminal.
26

Adjusting the PC image manually

Ordinarily you can easily adjust the picture as necessary
to change image position using "Auto Sync.". In some
cases, however, manual adjustment is needed to
optimise the image.
Setup
Fine Sync.
1 Press a/b to select the specific
adjustment item.
2 Press c/d to adjust the item to the
desired position.
H-Pos. [ 0] -30
[-5]
-20
V-Pos.
Clock [ 0]
-15
[ 0]
Phase -15
Centres the image by moving it to the left or
H-Pos.
right.
Centres the image by moving it up or down.
V-Pos.
Adjusts when the image flickers with vertical
Clock
stripes.
Adjusts when characters have low contrast or
Phase
when the image flickers.
NOTE
• For resetting all adjustment items to the factory preset values,
press a/b to select "Reset", and then press ;.
• "Clock" and "Phase" in the "Fine Sync." menu can be adjusted
only when inputting analogue signals through the EXT 4
terminal.
b30
b20
b15
b15
Item