Mobile Home Installation; Reversing Door Swing - Frigidaire FGQ1452HE1 Installation Instructions Manual

,
,
MOBILE HOME INSTALLATION
Dryer MUSTbe exhausted outside (outdoors, not beneath the
mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm)in
diameter with no obstructions. Rigid metal duct is preferred.
If dryer is exhausted through the floor and area beneath the
mobile home is enclosed, the exhaust system MUST terminate
outside the enclosure with the termination securely fastened
to the mobile home structure.
,
,
,
6.
When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to be
not less than twice the area of the dryer exhaust outlet.
This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 346764 is available from your dealer.
Referto pages2 and 3 for other important venting requirements.
Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which is a Federal Regulation
Title 24 CFR-Part32-80) or when such standard isnot applicable,
with American National Standard for Mobile Homes.
The dryer isdesigned under ANSI Z 21.5.1 or ANSI/
UL21 58 - CAN/CSA C22.2 (latest editions) for HOME USE only.
\ )'
I
Correct
L
_iill
ii _: i _
DON'T
'\. S
incorrect
L
REVERSING DOOR SWING
Sofid Door Reversing Instructions:
1. Open door and remove four (4) plugs in the door opening
opposite the hinges. Retain all parts for uses later, un-
less otherwise noted. Note: Use care in removing plugs
in not scratching paint on the front panel.
REMOVE 4 SCREWS
(ONE FROM EACH
HINGE FIRST)
,
Begin removing the four (4) screws that attach the hinge
to the front panel. For best results, start by only removing
one screw per hinge. Then only loosen the two remaining
screws while firmly holding door to prevent damage to
hinge, front panel or door. After the remaining screws are
loosened, continue to remove all.
3. Place door handle side down on a towel or pad to prevent
any possible scratches to door. Remove all remaining
four (4) screws between hinge and door.
4. Remove four (4) screws on opposite side of door.
5. Separate inner door from outer door by placing a flat screw
driver or putty knife. Rotate the inner door 180 degree
and reassemble the two door halves.
6. Install four (4) screws securing door halves where hinge
was previously attached.
7. Install four (4) screws securing hinge to door assembly.
8. Remove striker and discard.
9. Remove square plug and reinstall in hole striker was just
removed.
l O.Install striker (included in literature bag)into hole square
plug was previously installed.
11.Grasping firmly the top of the door, position the door near
the door opening and align the top hinge hole to the top
hole in the front panel door opening. Once the first screw
is started, attach the second screw to the lower hinge.
Once both screws are tightened, install the remaining
two screws.