Table of Contents
Advertisement
UNDER
COUNTER
& STACK
MODELS
ROUGH-IN
DIMENSIONS
_
-[223
33/4"
(9.5 cm)
_
ELECTRIC CONNECTION
2 9/16'---_
(6.5cm)
(34.4 cm)
I
©
/
L__
318" (0.96 cm) DIA.
GAS PiPE
UNDER
COUNTER
34 5/8"
(87.9 cm)
1"(2.54cm)
REAR VIEW
36""
(91.5cm)
DOOR OPEN 90 °
D
47 1/2"
(120. 7 cm)
4 3/8"
(11.1 cm) -_
OPTIONAL
VENTKNOCKOUT_,_
27'
(68.6 cm)
SIDE VIEW
J
3 3/4"
(9.5 cm)
MOBILE
HOME
INSTALLATION
1. Dryer MUST be exhausted outside (outdoors, not beneath
the mobile home) using metal ducting that will not support
combustion. Metal ducting must be 4 inches (10.16 cm)in
diameter with no obstructions. Rigid metal duct is preferred.
2. If dryer is exhausted through the floor and area beneath the
mobile home is enclosed, the exhaust system MUST terminate
outside the enclosure with the termination securely fastened
to the mobile home structure.
3. When installing a gas dryer into a mobile home, a provision
must be made for outside make up air. This provision is to be
not less than twice the area of the dryer exhaust outlet.
4. This dryer MUST be fastened to the floor. Mobile Home
Installation Kit No. 137067200 is available from your dealer.
5. Refer to pages 2 and 3 for other
important
venting
requirements.
6. Installation MUST conform to current Manufactured Home
Construction & Safety Standard (which isa Federal Regulation
Title 24 CFR-Part 32-80) or when such standard is not
applicable, with American National Standard for Mobile
Homes. In Canada, the CSA Z240 is applicable.
The dryer is designed under ANSI Z 21.5.
for
HOME USE only.
Z_
Correct
Do,
\ /
Incorrect
L
Correct
Incorrect
Incorrect
13
Advertisement
Table of Contents
