GE DNCK440EG7WC Installation Instructions Manual page 6

Installation Instructions
t ARAGE INSTALLATION (IF ALLOWED
BY LOCAL CODES)
ryers installed in garages must be elevated 18 inches
6cm) above the floor.
1161DRYEREXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
WARNING - BEFORE PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE TO
WEAR GLOVES
REMOVE
SCREW
AN DSAVE.
REMOVE,_
DESIRED
KNOCKOUT
lONE ONLY).
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the drger exhaust duct
and save. Pull the duct out of the drger.
Note: Only 4" round rigid metal ducting allowed inside
drger.
FIXING HOLE
B A
9"
Cut the duct as shown and keep portion A.
TAB LOCATION
BENDTAB
UP45 o
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 450 using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
RIGHT O R
LEFT SIDE
EXHAUST
Reconnectthe cut portion (A)of the duct to the blower
housing. Makesure that the shortened duct is aligned with
the tab in the base. Usethe screw saved previouslyto secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal
duct.
CAUTION:
Be sure not to pullor dQmoge the
electrical wires inside the dryer when inserting the
duct.
EXHAUST CAN
BE ADDED TO
LEFT O R RIGHT S IDE
\
DUCT
TAPE
6