Advertisement
Installation
Instructions
[]
MOBILE OR MANUFACTURED
HOME
INSTALLATION
• Installation must conform to the MANUFACTUREDHOME
CONSTRUCTION& SAFETY STANDARD, TITLE 24, PART
:32-80 or, when such standard is not applicable, with
AMERICAN NATIONAL STANDARD FOR MOBILE HOME,
ANSI/NFPA NO. 501B.
• The dryer MUST be vented to the outdoors with the
termination
securely fastened
to the mobile
home
structure. (See EXHAUSTINFORMATIONsection 6).
• The vent MUST NOT be terminated beneath a mobile or
manufactured home.
• The vent duct material MUSTBE METAL.
• KIT14-D346-33 MUSTbe used to attach the dryer securely
to the structure.
• The vent MUSTNOT be connected to any other duct, vent,
or chimney.
• Do not use sheet metal screws or other fastening devices
which extend into the interior of the exhaust vent.
• Provide an opening with a free area of at least 25 sq. in.
for introduction of outside air into the dryer room.
• Stacking of a gas dryer is not permitted in a mobile home
or manufactured home.
I_l GARAGE INSTALLATION
(IF ALLOWED
BY LOCAL CODES)
• Dryers installed in garages must be elevated 18 inches
(46cm) above the floor.
[] DRYER EXHAUST
TO LEFT OR BOTTOM
-tlLWARNING - BEFORE P ERFORMING
THIS EXHAUST INSTALLATION,
BE SURE
TO DISCONNECT
THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR
HANDS AND ARMS FROM SHARP EDGES
WHEN WORKING INSIDE THE CABINET.
BE SURE TO WEAR GLOVES.
REMOVE
SCREW
AND SAVE,
C %MZo o Sdp
(ONE ONLY),
Detach and remove the bottom or left side knockout as
desired. Remove the screw inside the dryer exhaust duct
and save. Pullthe duct out of the dryer. Protect sharp edges
around the knockout and exhaust opening with the tape.
FIXING H OLE s
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
UP45°
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 450 using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
_..
LEFTSIDE
EXHAUS]
Reconnect the cut portion (A)of the duct to the blower
housing. Make sure that the fixing hole is aligned with the
tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT SIDE OF CABINET
• Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
• Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal duct.
CAUTION:
Be sure not to pullor damage the
electrical
wires inside the dryer when inserting
the duct.
DUCT
TAPE
Advertisement
