GE GTDS820ED0WS Installation Instructions Manual page 9

Installation Instructions
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
. Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
. Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal duct.
CAUTION:
Be sure not to pull or damage the
electrical wires inside the drger when inserting the duct.
EXHAUST CAN
BEADDED T O
LEFT OR RIGHT S IDE
DUCT
TAPE
. Apply duct tape as shown on the joint between the
dryer internal duct and the elbow.
0
CAUTION:
Use 4" rigid metal ducting onlg
inside the drger. Internal duct
joints must be secured with
tape, otherwise theg mag sepa-
rate and cause a safetg hazard.
ADDING ELBOW FOR EXHAUST
THROUGH BOTTOM OF CABINET
. Insert the elbow through the rear opening and connect
it to the dryer internal duct.
.Apply duct tape on the joint between the dryer internal
duct and elbow, as shown on page 6.
CAUTION:
Internal duct joints
must be secured with
tape, otherwise they
/j/
mag separate and cause
a safetg hazard.
ADDING COVER PLATE TO REAR OF
CABINET (SIDES AND BOTTOM EXHAUST)
J
PLATE
(KIT W E1M454)
Connect standard metal elbows and ducts to complete
the exhaust system. Cover back opening with a plate
(Kit WEIM454)is available from your local service provider.
Place with dryer in final location.
AWA I G
NEVER LEAVE THE BACK OPENING
WITHOUT THE PLATE.
(Kit WE1M4541