Rerirculating; Attach Mounting Plate To - GE JVM2070 Installation Instructions Manual

Installation Instructions
RECIRCULATING
(Non-VentedDuctless)
INSTALLATION OVERVIEW
C1. Attach ]Vhmnting Plate to Wall
C2. Prepare Top Cabinet
C3. Check Microwave Assembly
C4. At!just Blower
C5. Mount the Microwave Oven
C6. Install Charcoal Filter
I
I
/°"
/
I-_ ATTACH THE MOUNTING
PLATE TO THE WALL
[
_OOOoooOoo*Oo
\ =
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
_ Remove the toggle wings from the bolts.
_ Insert the bolts into the motmting plate through
the holes designated to go into drywall and
reattach the toggle wings to '_A" onto each bolt.
To use toggle bolts:
Spacingfor Toggles
MoreThanWall
+l_-4.--Th
ckness
ToggleWings
Mounting
Plate_
Bolt End
_ Place the motmting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: Betore tightening toggle bolts and wood
scre_, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered trader the cabinet.
CAUTION: Be careflfl to axoid I)inching, fingers,
between the back of the motmting plate and the wall.
_ Tighten all bolts. Pull the plate awm from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need
to drill holes for the top support screws and
a hole large enow,h for the power cord to fit throuoh
L
" Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it tmderneath the top cabinet.
" Drill the holes, fi_llowing the instiuctions on the
TOP CABINET TEMPLATE.
CAUTION: XArear satety goggles when drilling holes
in the cabinet bottom.
19