Plate To; Prepm_Ltion Of Top Camnet; Adapting Microwave Blower Tor Outside Back Exhaust - GE JVM2070 Installation Instructions Manual

Installation Instructions
ATTACH THE MOUNTING
PLATE TO THE WALL
ili
: ii
I
I
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
_ Remove the toggle wings fl'om the bolts,
[]Insert the bolts into the motmting plate through
the holes designated to go into drywall and reattach
the toggle wings to :_A"onto each bolt.
To use toggle bolts:
Mounting
Plate
Spacing for TogglesMore
-"-I*-"-i*_ ThanWall Thickness
i
ToggleWings
B01tEnd
[]Place the motmting plate against the wall and
insert the toggle wings into the holes in the wall
to mount the plate.
NOTE: getOre tightening toggle bolts and wood
scre_, make sure the tabs on the mounting plate
touch the bottom of the cabinet when pushed flush
against the wall and that the plate is properly
centered under the cabinet.
CAUTION: Be careflfl to axoid I)inchin(*_ fingers
between the back of the motmting plate and the wall.
[]Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
USE TOP CABINET TEMPLATE
FOR PREPARATION OF TOP
CABINET
You need to drill holes for the top support screws and
a hole large enouoh for the power cord to fit throu ,h
%
" Read the instructions on the TOP CABINET
TEMPI,ATE.
" Tape it tmderneath the top cabinet.
" Drill the holes, following the instructions on the
TOP CABINET TEMPLATE.
CAUTION: Wear safety goggles when drilling holes
in the cabinet bottom.
ADAPTING MICROWAVE
BLOWER FOR OUTSIDE
BACK EXHAUST
_ Remoxe and that holds blower motor sa'_e sci'ew
to IllicI'owa'_ e,
BlowerMotor
_._...... Backof
Microwave
_2 rM°t°r
_ Careflfll) the blower unit. The wires pull
o/1[
will extend far enough to allow you to a(!iust the
blm_er unit.
BEFORE: EndB
Fan Blade _-_ II_ I ["
Openings ((_,1
[[[:_ [
]
,aoi°,uo
EndA _"__
16