Table of Contents
Advertisement
room Sensor and Air grill Installation
room Sensor Installation
Fig. 16
The room sensor is a small temperature sensor on the end
of a 60" gray or black wire. This sensor is installed much like
a standard wall thermostat. Because it is so small, it can be
hidden along the trim of a doorway or even up the leg of a
coffee table. There is a remote room sensor port on the rear
of the unit for easy external connection. Use standard 18-2
thermostat wire to extend the distance to the desired location
(50' maximum). The room sensor should be installed in the
location where you want to control the temperature.
NOTE: Distances of more than 25 feet from the unit or in
another room are not recommended. It is recommended
that the room sensor be installed, even if only installed on
the rear of the unit as a return air sensor. The room sensor
is essential for the Advance's excellent efficiency.
12
Room Sensor Outlet
Air grill Installation
Center Hooks
Fig. 17
Insert the two tail end hooks of the Air Grill Assembly up
under the stove top edge. Insert inward until the two center
hooks drop into the stove body slots in the front of the unit.
rEmINdErS
Do not allow pellets or sawdust to build up on the hopper
lid gasket.
Inspect the hopper lid gasket for damage. A good hopper lid
seal is very important for proper operation.
Hopper Lid Foam Gaskets
Fig. 18
Tail End Hooks
1-90-09730R29_02/14
Advertisement
Table of Contents
