Table of Contents
Advertisement
Hand Hole
Side Door
Fig. 9
Side Door Magnets
Lag Bolt Hole
Fig. 10
#10 hex head screws
Pallet Hold Down Bolts
Fig. 11
10
removing Side doors for Installation
Fig.12
removing Side doors
Figure 9
Use hand hole to swing open side doors to at least 90°.
Figure 10
Remove side doors by lifting upward on the door until the
bottom pin is out of its hole. Move the bottom of the door out
and away from the pedestal base about 1/2". Allow the door
to slide downward until the top door pin is out of its top hole.
NOTE: Always remove the side doors and rear shields to
move the unit. This will keep them from getting damaged.
removing the rear motor Shield Sheet metal.
NOTE: Disconnect power to the unit before removing the
motor shields. Danger of electrical shock. Hot and moving
parts could cause injury.
Figure 11
There are (2) #10 hex head screws holding each rear shield.
Using a 5/16" nut driver or socket, loosen the (2) screws
about 4 or 5 turns.
Figure 12
Slide the rear shields straight outward until the ends come
out of the rear retaining clips, as seen in Fig.13.
There are two bolts holding the stove to the pallet (see Fig.
11) Remove the bolts to move the stove.
Placing rear Shields back on unit
1. When replacing the shields, always insert the top and
bottom ends of the sheet metal into the retaining clips first.
2. Slide the shields straight inward until the (2) hex head
screws are fully inserted into the stove slots.
3. Make sure the top edges of the shield are against the
hopper bottom and tighten screws.
The rear shields are split around the flue tail pipe and outside
air knockout. This allows removal and installation of the rear
shields with the unit completely installed.
Rear Shield Retaining clip
Fig.13
Outside Air Knockout
1-90-09730R29_02/14
Advertisement
Table of Contents
