Paneldimensions - GE ZIC360N RH Design & Installation Manual

Design Guide
1/4" FRAMED PANEL DIMENSIONS
If you choose to install framed panels, they must be
cut to the dimensions shown. The panels will slide
into the frame on the door, drawer and grille.
If the custom panel is less than 1/4" thick and if it fits
loosely in the door frame, it can be backed up with a
piece of filler material or foam tape to improve the fit.
IMPORTANT NOTE: Maximum weight for fresh
food panel is 50 pounds and 30 pounds for freezer
drawer panel.
I Door/Drawer
I
I
I
I
k
\
1 5/16,'
L Trim
Reveal
1/4"
Panel
F eshFood
Panel
FramedPanel Dimensions
A (Width) B (GrilleHeight) C (FFHeight) D (FZHeight)
114"Framed Panel 33-7/8" 8-7/8" 46-1/16" 21-7/8"
OverlayPanel Dimensions
A (Width) B (Grille Height) C (FF Height) D (FZHeight)
1/4"Backer Panel 33-718" 8-7/8" 46-1/16" 21-718"
0.1if' Spacer Panel 32-112" 7-5/8" 44-11/16" 20-112"
3/4" Overlay Panel 34-118" 9" 46-5/16" 22"
3/4" OVERLAY PANEL DIMENSIONS
For a more custom appearance, overlay panels may be
installed on trimmed models. The overlay panel must
be secured to a 1/4" thick backer panel which slides
into the trim. A spacer panel 0.10" thick must be placed
between the overlay and backer panel.
IMPORTANT NOTE: Maximum total weight for
assembled fresh food panel is 50 pounds and 30
pounds for freezer drawer panel.
Assemble the panels with glue and screws.
* Center the spacer panel on the backer panel, left to
right and top to bottom. Secure the panels with glue.
* Center the spacer and backer panel on the overlay
panel and secure with glue and screws. Screws must be
countersunk into the backer panel.
Door/Drawer
1/4"
Backer
Panel
3veda
Panel
_,10 Inc
Spacer
_acker Panel !
NOTE: Left-to-right offset is not always equal to
top-to-bottom offset.
7