Step 1, Remove Packaging; Step 2, Install Water Line - GE ZIC360N RH Design & Installation Manual

Installation Instructions
[STEP 11 REMOVE PACKAGING
CAUTION:
Refi'igerator ismuch heavier atthe
top thanatthebottom - be careful w hen moving.
When using a hand truck, handle from side only.
PRUDENCE:
Le r0frig_rateur
est beaucoup plus
lourd en haut qu'en bas. Ii faut 0tre prudent lots des
d0placements. Si un diable est utilis0, il faut soulever
le rOfrig0rateur sur le c6t0 seulement.
* Carefully cut banding at the top and bottom, remove
outer carton.
* Slide out back corner posts (2).
* Slide carton off top of cabinet.
NOTE: IT IS NOT NECESSARY TO LAY CABINET
DOWN IN ORDER TO REMOVE SKID!
* The unit is secured to the skid with 4 slotted tie-down
straps. Remove the four 5/16" bolts from the base
channels in the tie-downs.
• Remove the four 7/16"
bolts securing the straps
to the skid.
CAUTION: DO
NOT ATTEMPT TO
ROLL UNIT OFF SKID.
Remove
__ owns
ie 9
PRUDENCE:
IL
NE FAUT PAS ESSAYER
DE FAIRE ROULER LE
RI_FRIGI_RATEUR POUR
L'ENLEVER DE LAY
PALETTE.
, Support blocks on the bottom of the refrigeration
case must be removed before sliding unit off skid or
damage will occm: Carefully, tilt refrigerator and
slide blocks out from beneath, slide unit off skid.
• Remove toekick. Set aside for final installation.
STEP 2] INSTALL WATER LINE
• A cold water supply is required for automatic ice-
maker operation. The water pressure must be be-
tween 40 and 120 p.s.i.
• Route 1/4" OD copper tubing between house cold
water line and the water connection location.
• Copper tubing should be long enough to extend to
the front of the refrigerator. Allow enough tubing to
accommodate bend leading into the water line
connection.
Shut off tile main water supply.
Turn on the nearest faucet long enough to clear the
line of waten
* Install a shut-off valve between the icemaker water
valve and cold water pipe in a basement or cabinet.
The shut-off valve should be located where it will be
easily accessible.
NOTE: It is best to install the valve into a vertical water
pipe. If you install the valve into a horizontal water
pipe, make the connection at the top or side, to
avoid drawing off any sediment from the water pipe.
. Drill a 1/4" hole in the water pipe.
* Fasten the shut-off valve to the pipe with pipe clamp.
. Tighten the clamp screws until the sealing washer
begins to swell. Do not over tighten.
. Place a compression nut and ferrule (sleeve) onto the
end of the tubing and connect it to the shut-off valve.
Make sure the tubing is fully inserted into the valve
and ferrule is tightened.
. Turn on the main water supply and flush debris. Run
about a quart of water through the tubing into a
bucket. Shut off water supply at the shut-off valve.
KCopper Tubin{
Saddle Type
OutletValve
Compression Nut
\
Ferrule
(Sleeve)
NOTE: Saddle type shut-off valves are included in
many water supply kits. Before purchasing, make sure
a saddle type valve complies with your local plumbing
codes.
NOTE: Commonwealth of Massachusetts Plumbing ]
Codes 248CMR shall be adhered to. Saddle valves
are illegal and use is not permitted in Massachusetts.
Consu t with your icensed p umber.
10