Step 9, Install; Step 10, Connect; Step 12, Install - GE Monogram ZV1050 Installation Instructions Manual

Installation Instructions
STEP 10 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING: fl,o.se wi,-in s.ot
with a ground wire, a ground must be provided by the
installer. When house wiring is aluminum, be sure
to use UL approved anti-oxidant compound and
aluminum-to-copper connectors.
AVERTISSEM ENT : si l ec ,bl ,ge
de la maison n'est pas du type f, deux ills avec un fil
de terre, l'installateur dolt fournir un circuit de terre.
Quand les ills de la maison sont en aluminium,
il prendre soin d'ufiliser de la piite antioxidafion
approuv_e par UL et des connecteurs pour
l'aluminium-cuiwe.
• Install strain relief onto the knockout of the junction
box coveI;
• Insert house wiring through strain relief and tighten.
• Connect white leads to branch circuit white lead.
• Connect black leads to branch circuit black lead.
• Connect green/yellow leads to branch circuit green
or bare ground lead.
• Secure all connections with wire nuts on each
electrical connectoL
• Push wires into junction box and replace coveL
Be sure wires are not pinched.
STEP 11 SLIDE DUCT COVER DOWN
Install
Decorative
Screw ,_
• Hold the decorative duct cover and remove the
decorative stop screw flom the support flame.
Keep the screw.
• Slide the lower duct cover down onto the hood.
• Install the decorative screw in the lower left hole on
the duct cover as shown.
14