Connecting Using Easy Connect Mode (Wireless Lan) - Epson EasyMP EMP-765 Setup Manual

Connecting Using Easy Connect Mode (Wireless LAN)

This section describes the procedure for connecting a projector to a network and
projecting images from a computer, and also how to disconnect the projector in easy
connect mode.
At computer
Install the EasyMP software
(included)
Make the wireless LAN (ad hoc
mode) connection settings
Start EMP NS Connection
Carried out first
time only
Tip :
The optimum performance can be obtained if the resolution of the computer being used
is XGA or lower and the colour settings are for 32-bit colour (Windows) or Thousands
(Macintosh).
Caution :
Do not remove the wireless LAN card while the access lamp of the wireless LAN card is
flashing green, otherwise it may damage the wireless LAN card.
s
p.14
Insert the wireless LAN card
Make the easy connect mode settings in
"Basic Wireless LAN Settings"
sp.26
Start EasyMP
(connection standby mode)
s
p.42
Carried out second and
subsequent times
At projector
s
p.19
sp.21
s
p.41
21