Kenmore 630.1390 Installation Manual page 3

Read theseinstallatlon instructions c ompletely
a nd follow
them carefully. They will save you time and effort and help
to ensure safety and optimum dishwasher performance.
if the dishwasher is installed in a lacatlon that experiences
Freezing temperatures (e.g., in a hallday home), you must
drain all the water from the dishwasher's interior. Water
system ruptures that occur as a result of freezing are NOT
COVERED BY WARRANTY.
iMPORTANT
• The dishwasher drain hose must be installed with a portion
of it at least 20" (508mm) off the cabinet floor; otherwise
the dishwasher may not drain properly.
This dishwasher is intended for indoor residential use
only, and should not be used in commercial food service
establishments.
This dishwasher is designed to be enclosed on the top and
both sides by cabinetry.
NEW INSTALLATION - If the dishwasher isa new installation,
mast of the work must be done before the dishwasher is
moved into place.
REPLACEMENT - If the dishwasher is replacing another
dishwasher, check the existing dishwasher connections for
compatibility with the new dishwasher, and replace parts
as necessary.
• This appliance has been found to be in compliance with
CAN/CSA-C22.2 No. 167/UL 749. it is the responsibility
of the owner and the installer to determine if additional
requirements and standards apply in specific installations.
• Not for outdoor use.
OTHER iMPORTANT iNFORMATiON
inspect the Dishwasher
After unpacking the dishwasher and prior to installation,
thoroughly inspect the dishwasher for possible freight or
cosmetic damage. Report any damage immediately. Cosmetic
defects must be reported within 30 days of installation.
NOTE: Do not discard any bags or items that come with the
original package until after the entire installation has been
completed.
Electrical Supply Cable - Minimum #14 AWG
2 conductor, 1 ground, insulated copper
conductors rated 75°C (167°F) or higher.
Hot Water Supply Line - Minimum 3/8"
O.D. copper tubing, PEX, or metal braided
dishwasher supply line.
Shut-off valve and fittings appropriate
for hot water supply line (copper tubing/
compression fitting, or braided hose).
90 ° elbow with 3/8" N.P.T. male threads on
one leg, and sized to fit your water supply line
(copper tubing!compression fitting, or braided
hose) on the other leg.
Thread seal tape or other pipe sealant
compound to seal plumbing connections.
UL listed conduit connector or strain relief.