Table of Contents
Advertisement
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to folow
these instructions can result in death,
fire, or electrical shock.
5. Plug into a grounded 3 prong outlet.
1=
2=
1=
2.
On models with a storage drawer, remove the storage drawer.
See "Storage Drawer" section.
On models with a warming drawer, the rear leg cannot be
seen by removing the warming drawer. It will be necessary to
view the rear foot from outside the range.
To check that the anti-tip bracket is installed, use a flashlight
and look underneath the bottom of the range.
•
Look for the anti-tip bracket securely attached to floor.
•
Slide range back so rear range foot is under anti-tip
bracket.
Place a rack in oven.
Place level on rack and check levelness of range, first side to
side; then front to back.
3=
If range is not level, pull range forward until rear leveling leg is
removed from the anti-tip bracket.
On Ranges Equipped
with Storage Drawers:
Use a W' drive ratchet, wrench or pliers to adjust leveling legs
up or down until the range is level. Push range back into
position. Check that rear leveling leg is engaged in the anti-tip
bracket.
On Ranges Equipped with Warming Drawers:
Use a wrench or pliers to adjust leveling legs up or down until
the range is level. Push range back into position. Check that
rear leveling leg is engaged in the anti-tip bracket.
NOTE: Range must be level for satisfactory
baking
performance.
Initial lighting and gas flame adjustments
Cooktop and oven burners use electronic igniters in place of
standing pilots. When the cooktop control knob is turned to the
"LITE" position, the system creates a spark to light the burner.
This sparking continues, as long as the control knob is turned to
"LITE."
When the oven control is turned to the desired setting, sparking
occurs and ignites the gas.
Check Operation
of Cool(top
Burners
Standard
Surface
Burners
Push in and turn each control knob to the "LITE" position.
The flame should light within 4 seconds. The first time a burner is
lit, it may take longer than 4 seconds to light because of air in the
gas line.
If burners
do not light properly:
•
Turn cooktop control knob to the "OFF" position.
•
Check that the range is plugged in. Check that the circuit
breaker has not tripped or the household fuse has not blown.
•
Check that the gas shutoff valves are set to the "open"
position.
•
Check that burner caps are properly positioned on burner
bases.
Repeat start-up. If a burner does not light at this point, turn the
control knobs to "Off" and contact your dealer or authorized
service company for assistance.
Adjust Flame Height
Adjust the height of top burner flames. The cooktop "low" burner
flame should be a steady blue flame approximately
W' (0.64 cm)
high.
A
_
I_
kn.l I_
kn.l I_
knJ
/
B
k_
krJ k_
krJ k_
krJ
A. Low flame
B. High flame
Advertisement
Table of Contents
