Advertisement
g.
Move range into its final location making sure rear leveling leg
slides into anti-tip bracket.
10. If installing the range in a mobile home, you must secure the
range to the floor. Any method of securing the range is
adequate as long as it conforms to the standards in the
"Location Requirements" section.
11. Continue installing your range using the following installation
instructions.
Power Supply Cord
Electrical Shock Hazard
Disconnect power before servicing.
Use a new 40 amp power supply
cord.
Plug into a grounded outlet.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
Direct Wire
Electrical
Shock Hazard
Disconnect
power before servicing.
Use 8 gauge copper
or 6 gauge aluminum
wire.
Electrically
ground
range.
Failure to follow these instructions can result in death,
fire, or electrical
shock.
1=
2.
Disconnect
power.
Remove the terminal block cover screws located on the back
of the range. Pull cover down and toward you to remove cover
from range.
%
L
3. Remove plastic tag holding three 10-32 hex nuts from the
middle post of the terminal block.
4. Add strain relief.
Style 1: Power supply cord strain relief
•
Remove the knockout for the power supply cord.
C
A. Two mounting
tabs each side
B. Terminal block cover
C. Hex-head screws
6
Advertisement
