Advertisement
Quick Links
INSTALLATIONINSTRUCTIONS
30" (76 CM) FREESTANDING ELECTRICRANGES
Table of Contents
RANGE SAFETY .............................................................................
1
INSTALLATION REQUIREMENTS
................................................
2
Tools and Parts ............................................................................
2
Location Requirements ................................................................
2
Electrical Requirements
..............................................................
3
INSTALLATION
INSTRUCTIONS ..................................................
4
Unpack Range ..............................................................................
4
Install Anti-Tip Bracket .................................................................
5
Electrical Connection ...................................................................
6
Verify Anti-Tip Bracket Location ..................................................
9
Level Range ..................................................................................
9
Complete Installation .................................................................
10
Moving the Range ......................................................................
10
ANTI-TIP BRACKET TEMPLATE
...............................................
11
RANGE SAFETY
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
You can be killed or seriously injured if you don't immediately
follow
instructions.
You can be killed or seriously injured if you don't follow
instructions.
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect anti=tip bracket to rear range foot.
Reconnect
the anti=tip bracket,
if the range is moved.
Failure to follow
these instructions can result in death or serious burns to children
and adults.
iMPORTANT:
Save for local electrical inspector's use.
W10196158B
Advertisement
Related Manuals for Amana AER3311WAW0
Summary of Contents for Amana AER3311WAW0
- Page 1 INSTALLATIONINSTRUCTIONS 30" (76 CM) FREESTANDING ELECTRICRANGES Table of Contents RANGE SAFETY ................INSTALLATION REQUIREMENTS ..........Tools and Parts ................Location Requirements ..............Electrical Requirements .............. INSTALLATION INSTRUCTIONS ..........Unpack Range ................Install Anti-Tip Bracket ..............Electrical Connection ..............Verify Anti-Tip Bracket Location ..........Level Range ..................
- Page 2 INSTALLATION REQUIREMENTS Gather the required tools and parts before starting installation. IMPORTANT: Observe all governing codes and ordinances. Read and follow the instructions provided with any tools listed • It is the installer's responsibility to comply with installation here. clearances specified on the model/serial rating plate. The Tools needed model/serial rating plate is located on the left side frame...
- Page 3 Product D imensions ..,,i_i_iiiiiiiil iiiiliiiiiii!!iii!! _iii ili;i iiiiiiiii i!!ii ; ilii !iiiiiii_li,!@_ ..A. 13" (33.0 cm) max. upper cabinet depth B. 30" (76.2 cm) min. opening width C. For minimum clearance to top of cooktop, see NOTE*. D. 301/8'' (76.5 cm) min. opening width E.
- Page 4 Electrical Connection If connecting to a 4-wire system: To properly install your range, you must determine the type of This range is manufactured with the ground connected to the electrical connection you will be using and follow the instructions neutral by a link. The ground must be revised so the green provided for it here.
- Page 5 On Ranges Equipped with Storage Drawers: 2. Place template on the floor in cabinet opening so that the left edge is against cabinet and top edge is against rear wall, Remove the storage drawer. Use a ¼" drive ratchet to lower molding or cabinet.
- Page 6 Move range into its final location making sure rear leveling leg 10. If installing the range in a mobile home, you must secure the slides into anti-tip bracket. range to the floor. Any method of securing the range is adequate as long as it conforms to the standards in the "Location Requirements"...
- Page 7 Style 2: Direct wire strain relief 4-wire connection: Power supply cord • Remove the knockout as needed for the flexible conduit connection. Use this method for: • Assemble a UL listed conduit connector in the opening. • New branch-circuit installations (1996 NEC) •...
- Page 8 In an area where local codes prohibit grounding through the 3-wire connection: Power supply cord neutral Remove the ground-link screw from the range frame. Save Use this method only if local codes permit connecting cabinet- the ground-link screw and cup washer. Bend the ground-link ground conductor to neutral wire of power supply cord.
- Page 9 3-wireconnection: Direct w ire On models with a storage drawer, pull drawer open to first Use this method only if local codes permit connecting ground stop position. Lift front of drawer to clear white wheels in conductor to neutral supply wire. drawer guides.
- Page 10 For power supply cord-connected ranges: 1. Slide range forward. 1. Check t hatallparts arenow installed. Ifthere isanextra part, 2. Unplug the power supply cord. goback through t hesteps toseewhich step wasskipped. 3. Complete cleaning or maintenance. 2. Check t hatyouhave allofyourtools. 4.
- Page 11 ANTI-TIPBRACKET TEMPLATE Cut on dotted lines and place the left edge against the left side cabinet and the top edge against the rear wall. Top edge Use this template to anchor the left rear leg of range.
- Page 12 W10196158B © 2008. 8/08 Printed in U.S.A. All rights reserved.