Installation
DIMM Module Installation
Figure 9 displays the notch on the DDR DIMM memory module.
DIMMs have 184 pins and one notch that matches with the DDR DIMM socket.
DIMM modules are installed by placing the chip firmly into the socket and
pressing straight down as shown in figure 10 until the white clips close and the
module fits tightly into the DIMM socket (figure 11).
Figure 10 - DIMM module clips before installation
Figure 11 - DIMM module clip after installation
To remove the DIMM module press down the white clips and the module will be
ejected from the socket.
Page 3-8
CENTER KEY ZONE
(2.5 V DRAM)
Figure 9 - DIMM notch