Jenn-Air JEI0430ADS0 Installation Instructions Manual page 6

3-Wire Cable from Home Power Supply - U.S. Only
IMPORTANT: Use the 3-wire cable from power supply where local
codes permit a 3-wire connection.
A E
H
I
A. Cable from home power supply
B. Red wires
C. Green (or bare) ground wire
from cooktop
D. 3-wire cable (from cooktop)
E. Junction box
F White wire (from home
power supply)
G. UL listed wire connector
H. Black wires
I. UL listed or CSA approved
conduit connector with wire
bushing
1. Connect the 2 red wires (B) together using a UL listed wire
connector.
2. Connect the green (or bare) cooktop cable wire (C) to the
white (neutral) wire (F) in the junction box using a UL listed
wire connector.
3. Connect the 2 black wires (H) together using a UL listed wire
connector.
4. Install junction box cover.
,. ..... O© < Co J t' >t'l;op
NOTE: This section applies only if you are using clamping
brackets.
D
C .............. f
A. Clamping screw
B. Countertop
C. Foam seal
D. Cooktop
1. Place the 21/2 '' (6.4 cm) clamping screws into the brackets.
2. Check that the cooktop is level.
3. Use a flat-blade screwdriver to tighten the screws against the
countertop. Do not overtighten.
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. Dispose of/recycle all packaging materials.
3. Use a mild solution of liquid household cleaner and warm
water to clean cooktop before use. Dry thoroughly with a soft
cloth. For more information, see the "Cooktop Care" section
of the Use and Care Guide.
4. Read "Cooktop Use" in the cooktop Use and Care Guide.
NOTE: If the cooktop does not work after turning on the power,
check that a circuit breaker has not tripped or a household fuse
has not blown. See "Troubleshooting" section in the Use and Care
Guide for further information.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop