Table of Contents
Advertisement
Available languages
Available languages
Make sure thattheelectrical connection and wire size are
adequate andinconformance
withtheNational Electrical Code,
ANSl/NFPA
70-latest edition orCSA Standards C22.1-94,
Canadian Electrical Code, Part 1 and C22.2 No. O -M91-1atest
edition, and alllocal codes a ndordinances.
Acopy oftheabove c ode standards canbeobtained from:
National Fire Protection Association
One Batterymarch
Park
Quincy, MA02269
CSA International
8501 East Pleasant Valley R oad
Cleveland,
OH44131-5575
Before You Make the Electrical
Connection:
To properly install your cooktop, you must determine the type of
electrical connection you will be using and follow the instructions
provided for it here.
•
A 4-wire or 3-wire, single phase, 120/240 volt, 60 Hz., AC only
electrical supply is required on a separate, 40-amp circuit
(45" [114.3 cm] models) or 40-amp circuit (30" [76.2 cm]
models), fused on both sides of the line.
The cooktop should be connected directly to the junction box
in the cabinet through the flexible metal conduit. The flexible,
armored cable extending from the fuse box or circuit breaker
box should be connected directly to the cooktop wiring box.
Locate the junction box in the cabinet to allow as much slack
as possible between the junction box and the cooktop so that
the cooktop can be moved if servicing becomes necessary in
the future.
A UL listed or CSA approved conduit connector must be
provided at each end of the power supply cable (at the
cooktop wiring box and at the junction box in the cabinet).
•
If the house has aluminum wiring follow the procedure below:
1. Connect a section of solid copper wire to the pigtail
leads.
2. Connect the aluminum wiring to the added section of
copper wire using special connectors
and/or tools
designed and UL listed for joining copper to aluminum.
Follow the electrical connector manufacturer's
recommended
procedure. Aluminum/copper
connection must conform with
local codes and industry accepted wiring practices.
INSTALLATIONINSTRUCTIONS
....
.............%,00/{
O©
Decide on the final location for the cooktop.
Excessive Weight Hazard
Use two or more people to move and install cooktop.
Failure to do so can result in back or other injury.
1.
2.
3.
Open product as instructed on product packaging.
Remove shipping materials and tape from cooktop.
Remove vent grille and grates if present.
B
C
A
D
A. Vent grille (already removed)
B. Grates
C. Removable grease filter
D. Radiant element cartridge
4. Remove the removable grease filter by lifting the filter out.
5. Using 2 or more people, remove the cooktop from the carton.
6. Use foam end caps from the packaging as a work surface for
the floor or countertop.
7. Using 2 or more people, place the cooktop on the foam end
caps.
8. Avoid placing the cooktop face down on the control knobs.
9. Turn tie down bolt on each end of cooktop burner box bottom
counter clockwise so the bolt does not protrude beyond the
side wall of the buner box bottom.
10. For island or peninsula installations, go to the "Rotate Blower
- Optional" section.
8
Advertisement
Table of Contents
