Options; Options General View - GE LP33 Series 80 User Manual

8

OPTIONS

8.1

OPTIONS GENERAL VIEW

UTILITY INPUT
F1 F2 F3
g g g
Digital Energy Digital Energy Digital Energy
UPS System UPS System UPS System
LP33 Series 80 & 100 LP33 Series 80 & 100 LP33 Series 80 & 100
1 2 3
RPA RPA RPA
Board Board Board
LOAD
Modifications reserved
OPM_LPS_3UO_80K_M10_1US_V010.doc
LPS33U_080-100_RPA system_GE_01US
F4
g RPA kit
Digital Energy
UPS System
Redundant Parallel Architecture
LP33 Series 80 & 100
4
Allows extending the unit to a parallel system with 2, 3, or 4 units connected on the
RPA
Board
same bus, which ensure the highest reliability rate and increase the power
availability without prior investments.
Additional battery cabinets
For battery with extended backup time.
Dimensions (WxDxH):
25.66" x 31.50" x 75.00" / 650 x 800 x 1905 mm
47.84" x 31.50" x 75.00" / 1215 x 800 x 1905 mm
Customer Interface
The Customer Interface Card allows the client the exchange of information
(monitoring and control) with the following interfaces:
- Serial port RS232.
- 6 programmable output channels.
- 2 programmable input channels, of witch one for GEN-ON.
- EPO (Emergency Power Off).
3-ph SNMP/WEB plug-in adapter
The "3-ph SNMP/WEB plug-in adapter" is an Interface to the Ethernet Network, and
provides UPS information via the standard SNMP protocol (Simple Network
Management Protocol).
The UPS can therefore be managed by a Network Management System (NMS) or by
our applications (for instance JUMP), which uses this information to determine the
state of the UPS in order to guarantee safe and orderly shutdown of the server,
when needed.
GE Power Diagnostics
GE Power Diagnostics is an anytime, anywhere concept in UPS status monitoring
and alarm notification that has been successfully implemented in numerous of
installations supporting up to multi-hundred UPS.
Based on the leading Intelligent Remote Information System IRIS all GE UPS types as
well as 3rd party UPS are supported.
Accessing the latest site information via Web and being alerted by Email, SMS or
Fax, it enables the user to make timely decisions in case of changing critical
conditions.
With comprehensive data collection and analysis IRIS is not only a remote
monitoring & diagnostics (RM&D) system but, the core of the integrated service
offering GE Power Diagnostics.
GE Data Protection
GE Data Protection software can communicate with the UPS over RS-232, USB or
SNMP to receive status information and measurement values of the UPS.
In case of a critical condition (time on battery, remaining battery autonomy time or
low battery) for the load, the software starts a controlled shutdown.
An enhanced alarm management system provides the possibility to start applications,
send messages, and send e-mails for every upcoming or disappearing alarm.
Page 64/66
User Manual LP33 Series 80 & 100 UL S1