Using Sequence - Haier T60-32 User Manual

Using sequence

Preparation before spinning
Please make the machine stand horizontally.
Confirm that the washing machine is earthed reliably . Then insert the power plug I
nto the receptacle. Do not connect the earth terminal to the gas pipe and tap
water pipe.
Put down the drain hose .
Spin process
1 Put the laundyies in properly
2 Put the gland in properly
3 Close the inner and outer coverof the spin tub
4 Do you need water-added Rinsing-spinnning
Water-added rinsing-spinning has an effect that can remove the surplus liquid dirt,
It works in a way as follows:
Spin
Spin for about
1~2 minutes
Remove most of
the foam extra
detergent liquid.
Note: If there needs no
spinning directly.
The effect is best when the laundries quantity is below 80% of the rated value.
5 Select spin time
OFF
5
1
4
2
3
Spin timer
6 Take the laundry out when the spinning ends.
When the spinning ends, open the top lid and the interior lid. Then take out
the depression cover and laundry after the spinning drum has stopped
rotation completely.
Note:
Refer to the Notes on Spinning carefully.
Install the water inlet hose
The water hose should be connected
as shown in the right figure.
Fill water for
about 1 minutes
water-added rinsing-spinning , set the duration for
Select suitable spin time according to the laundries, and do spinning
Refer list 1 of page 3
Spin for about
1~2 minutes
Remove the detergent
liquid remained
Water inlet hose
Foam-removing
spinning
Water inlet entrance