Table of Contents
Advertisement
9b.
Standing
Pilot Oven
Burner
To light the oven pilot, proceed as follows:
Turn the oven thermostat
knob to OFF. Remove
oven
bottom,
see step 10 for instructions on removing the oven
bottom.
Light the oven pilot with a match. The oven pilot
should
burn with
a stable flame
after
a few
seconds
operation
and should have a small flame visible only at the
opening
in the top of the pilot assembly.
Turn oven thermostat
knob to 300°F. The oven pilot should
now be larger with the flame extending
down the slanted
ramp and burning against a small metal bulb.
Primary Pilot Flame
After 20-40
seconds,
the main oven burner
should ignite
and burn until the oven temperature
has reached 300°F. At
that time, the oven pilot should
get smaller, moving up
away from the metal bulb which will turn offthe main oven
burner after 20-40 seconds.
Secondary
Pilot Flame
The oven
burner
will continue
to turn
off
and
on to
maintain
oven temperature.
10.Air
Shutter-Oven
Burner
The approximate flame length of the oven burner is 1 inch
(distinct inner, blue flame).
To determine
if the oven burner flame is proper,
remove the
oven bottom
and burner baffle and set the oven to bake at
300°F.
To remove
the oven
bottom,
remove
oven
hold
down
screws at rear of oven bottom.
Pull up at rear, disengage
front of oven bottom
from oven front frame, and pull the
oven bottom
out of the oven. Remove burner baffle so that
the burner flame can be observe.
Waist-High Burner
(Self Clean Models
Shutter
Lower Oven Bottom
(Removable)
Air Shutter
If the flame is yellow in color, increase air shutter opening
size. (See '2" in illustration below.) If the flame is a distinct
blue, reduce the air shutter opening size.
To adjust loosen lock screw (see '3" illustration
below),
reposition air shutter, and tighten lock screw. Replace oven
bottom.
11.
Air Shutter-BroU
Burner
(if equipped)
The approximate flame length of the broil burner is 1 inch
(distinct inner, blue flame).
To determine
if the broil
burner
flame is proper,
set the
oven to broil.
If the flame
is yellow
in color, increase air shutter
opening
size (see "2" in illustration.)
If the flame
is a distinct
blue,
reduce the air shutter
opening
size.
To adjust, loosen lock screw (see'3" in illustration),
reposition
air shutter,
and tighten
lock screw.
8
Advertisement
Table of Contents
