Table of Contents
Advertisement
C.
Level and Position Range - Level range by adjusting
the (4) leveling legs with a wrench. Note: A minimum
clearanceof 1/8' is required between the bottom of the
range and the leveling leg to allow room for the
bracket. Use a spirit level to check your adjustments.
Slide range back into position. Visually check that rear
leveling leg is inserted into and fully secured by the
Anti-Tip Bracket by removing lower panel or storage
drawer. For models with a warmer drawer or broiler
compartment, graspthe top rear edge of the range and
carefully attempt to tilt it forward.
Range Side --_
_ _
2. Provide an adequate
gas supply.
This unit is designed to operate on 4" natural gas or 10" LP/
Propane manifold pressure. Aconvertible
pressure regulator
is connected
to the manifold
and MUST be connected
in
series with the gas supply line regardless of which type of
fuel is being used.
Care must be taken during installation of range not to
obstruct the flow of combustion and ventilation air.
For proper operation,
the maximum
inlet pressure to the
regulator
should
be no more than
14 inches of water
column pressure. The inlet pressure to the regulator
must
be at least I inch greater than regulator manifold pressure.
Examples: If regulator is set for natural gas 4 inch manifold
pressure, inlet pressure must be at least 5 inches; if regulator
has been converted
for LP/Propane
gas 10 inch manifold
pressure,
inlet pressure
must be at least 11 inches.
Leak testing of the appliance shall be conducted according
to the instructions in step 4g.
The gas supply
line should
be 1/2" or 3/4" I.D.
120V Outlet on Rear of
Wall and Area for Thru
the Wall Connection of
Pipe Stub and Shut Off
Valve is Shaded Area.
• " -- _Wall
the Floor Connection of
Edge
d Shut Off Valve.
3.
Seal the openings.
Seal any openings in the wall behind the range and in the
floor under the range after gas supply line is installed.
4.
Connect
the
range
to the gas supply.
To prevent leaks, put a pipe joint sealant on all male
(outside) pipe threads.
Your regulator is in one of the two locations shown below.
Do not allow
regulator
to turn
on pipe
when tightening
fittings.
II
II
Pressure Regulator location
4
Advertisement
Table of Contents
