Repair; Lifting The Vehicle; Wheels And Tires; Tire Repair - Bad Boy HD G Owner's Manual

OPERATION AND SERVICE INFORMATION
Read all of manual to become familiar with vehicle. Pay attention to all NOTICES, CAUTIONS, WARNINGS and DANGERS.
with lukewarm or cold water and mild detergent is
required to preserve the painted surfaces.
Occasional cleaning and waxing with non-abrasive
products designed for 'clear coat' automotive finishes
will enhance the appearance and durability of the
painted surfaces.
Corrosive materials used as fertilizers or for dust control
can collect on the underbody of the vehicle. These
materials will cause corrosion of underbody parts
unless flushed occasionally with plain water. Thor-
oughly clean any areas where mud or other debris can
collect. Sediment packed in closed areas should be
loosened to ease it's removal, taking care not to chip or
otherwise damage paint.
If the engine does not start or runs improperly after
washing, remove the spark plug wires (by pulling the
spark plug boots, never the wires). Dry all connections
with forced air. Reinstall the wires.

REPAIR

LIFTING THE VEHICLE

Tool List
Floor jack .................................................................... 1
Jack stands ................................................................. 4
Chocks ........................................................................ 4
Some servicing operations may require the front
wheels, the rear wheels, or the entire vehicle be raised.
To reduce the possibility of severe injury or
death from a vehicle falling from a jack:
Be sure the vehicle is on a firm and level
surface.
Never get under a vehicle while it is sup-
ported by a jack.
Use jack stands and test the stability of the
vehicle on the stands.
Always place chocks in front and behind the
wheels not being raised.
Use extreme care since the vehicle is
extremely unstable during the lifting pro-
cess.
When lifting vehicle, position jacks and jack stands at
the areas indicated only.
To raise the entire vehicle, install chocks in front and
behind each front wheel. Center the jack under the rear
frame crossmember. Raise the vehicle enough to place
a jack stand under the outer ends of the rear axle.
Lower the jack and test the stability of the vehicle on the
two jack stands.
Place the jack at the center of the front axle. Raise the
vehicle enough to place jack stands under the frame
crossmember as indicated.
Lower the jack and test the stability of the vehicle on all
four jack stands.
If only the front or rear of the vehicle is to be raised,
place the chocks in front and behind each wheel not
being raised to stabilize the vehicle.
Lower the vehicle by reversing the lifting sequence.
Qty.
View from Underside of Vehicle
Fig. 21 Lifting the Vehicle

WHEELS AND TIRES

Tire Repair

Tool List
Lug wrench, 3/4".......................................................... 1
Impact socket, 3/4", 1/2" drive ..................................... 1
Impact wrench, 1/2" drive ............................................ 1
Torque wrench, 1/2" drive............................................ 1
Center of
Front Axle
Flat Portion
of Frame
Outside End
of Rear Axle
Qty.
Page 13