Setting Hdmi And Component Output Resolution; Setting Channel Id - Entone Amulet User Manual

High definition television receiver

Hide thumbs Also See for Amulet:

Table of Contents

Amulet High Definition Television Receiver User's Guide

SETTING HDMI AND COMPONENT OUTPUT RESOLUTION

You can select 1080i, 720p, 480p or 480i on the HDMI and Component output. When you set the output,

both HDMI and Component outputs are set to the selected resolution, the "HD" indicator in front panel will

glow in blue if the resolution is set to720p or higher. The RCA Composite and RF outputs are always set to

480i and will not be affected by the HDMI and Component resolution setting. The resolution can be set in

the User Menu or the middleware. Please refer to the section "User Menu" on changing settings in the User

Menu.

NOTE: If your TV does not display the video or error message is displayed after you have selected a new

resolution, your TV may not support the selected resolution. Refer to your TV owner's manual for

verification. Repeat the above procedures again to find a resolution supported by your TV.

In "RF TV", channel 3/4 is used by default. You can change the channel ID by toggling the CH3/CH4 switch

at the rear panel.

NOTE: The new channel ID will take effect immediately after the switch is toggled.

Table of Contents

Show Quick Links

Table of Contents