Connecting The Tv Using Coaxial Cable; Setting Up Tv To Use Catv - Entone Amulet User Manual

Amulet High Definition Television Receiver User's Guide

CONNECTING THE TV USING COAXIAL CABLE

1. Use the coaxial cable that comes packaged with Amulet to connect your TV's antenna input to the
Amulet's "RF TV".
2. You can either select to use channel ID 3 or channel ID 4. You can change the channel ID by toggling
the CH3/CH4 switch at the rear panel.
3. Tune your TV to channel 3 or channel 4 to view the output.
NOTE:
In the "RF TV", CATV channel 3 or channel 4 is supported.
You can connect your home TV cable source to "ANT IN", then the "RF TV" will be multiplexed with
both the cable TV signal and the Amulet TV signal. The Amulet needs to connect to power main in
order to make the multiplexing work.
Figure 4-1 Connecting TV using Coaxial Cable

SETTING UP TV TO USE CATV

In order for the Amulet to feed video signal to TV using RF TV, your TV must be configured to receive signal
from CATV rather than from the antenna.
Most TVs use either a physical switch located on the rear of the TV or with on-screen programming to
configure to use CATV. Consult your TV owner's manual for instruction if required.
12
Copyright © 2008 Entone, Inc. All rights reserved
.